Do Yourself Concrete Lifting

Geolift can help to lift existing concrete surfaces and fix those problem areas around your house with much less labor.

Do yourself concrete lifting.

High density polyurethane foam is injected into holes that expand to lift and level the sunken concrete. Use diamond tipped core drill to bore several large diameter holes through slab. Polyfoam is stronger and longer lasting than traditional mudjacking. Injection holes are strategically drilled into the concrete slab s that requires lifting.

Hack to fix sunken concrete. You should also get a steel. Geolift works for driveways sidewalks patios garage floors even pool decks. Polyurethane foam is then injected under the slab filling voids and raising it to the correct level.

Concrete lifting with a small sledge hammer brick chisel and drill this is another method for doing it yourself. The first step is to drill holes in the problem concrete. With a concrete drill or masonry bit drill small holes into the sunken area and slowly pour a thin mixture of cement into the holes. Lifting a sunken slab may be necessary to level the surface.

And yes it is a foam just like your beloved spray foam. Hiring a professional service to lift or jack up the slab can be costly. The equipment is contained in a trailer rig with a long hose capable of reaching direct to the concrete slab location. Mix a small batch of fast setting concrete.

Add some of the concrete dust removed from the holes after drilling to the mix to tint the mix the same color as the slab. You can avoid this expense if you do it yourself with the help of a jacking pump which can raise the concrete slab to the needed level. Cut through slab with gas powered saw fitted with 12 inch diamond blade. That ll allow the sunken slab to lift up.

Fast setting concrete is necessary to patch the holes when you re finished filling them up. Basically you clean the concrete buy a bag of cement mix it up and dump it on top finish it yourself. Otherwise you could crack the concrete. You will want to add some reinforcement wire to prevent fracturing and probably use a surface preparing glue.

Place the concrete into a grout bag and inject it into the holes filling them up to the level of the slab s surface. Geolift works in three steps. Get a carpenter s level to make sure that you don t overfill the slab too high.