Detail Section Of Tile Meeting Up With Carpet

Place the flat side of the z bar on top of the ceramic tiles.

Detail section of tile meeting up with carpet.

Use scissors and a utility knife to trim the foam to fit just inside the tack strip. Cut the z bar to fit using a hacksaw. Staple the foam down. Knowing the proper way to tuck carpet against new hardwood floors can make the difference from not only appearance but avoiding a trip hazard.

A flat transition strip with straight edges can be the ideal choice. While you could simply end the carpet at the tile floor with a folded and tucked edge you may want to go with a more decorative border to mark the transition. Just under half an. The tack strip for the carpet is installed 1 4 to 3 8 inch from the edge of the tile then the edge of the carpet is cut off at the direct tile edge or it can span the slight gap between the tack.

If you ve decided on keeping the existing carpet in some areas where it meets up with the wood floor here are some pointers for you. Measure the width of the join between the ceramic flooring tiles and carpet. If you have a deep dark carpet in one room it may be best to avoid placing it directly up against a gleaming white marble in the next room. If you want to make a wise carpet selection and be sure to get your full monies worth you need to know what carpet grade or quality level of carpet you need to buy for your home.

Tuck the extra edge of the carpet under the gap and use the hooks of the transition strip to hold it in place. A new transition strip can be placed over an existing strip to both dress up and freshen up the look of the doorway. And if the carpet in the hallway is dark red you may not want to contrast this with a green carpet in the bedroom. If there s already a carpet there cut it just a few inches longer than where you want to meet the tile.

Installing carpet against wood floors. The next step should be to cut at the direct edge of the tile. Nail a section of tack strip 1 8 inch from the end cap using a hammer. Cut the edge of the carpet so that it reaches the edge of the tile perfectly.

Use this to minimize seams along the carpeted area and make a clean break between the flooring materials. Pull the carpet and foam back with your hand from the doorway. Mark donovan shows how to install carpet transition trim between vinyl and carpet flooring. Pull the carpet over the top using a knee kicker.

After the tile is installed put in a tack strip 1 4 to 3 8 inches from the edge of the tile.